Products > Integrated Conditioning Acquisition & Control Systems > Integrated Conditioning Acquisition & Control System Enclosures > Model 6008U  
Download PDF Download PDF     Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Model 6008U, Enclosure 4-Slot 12V DC USB Control & Data Interface



Features

  • DC Enclosure for 4 I/O Modules
  • USB 2.0 Interface provides 4.8 MS/s aggregate data rate
  • Calibration voltage input
  • Alarm busses for control external equipment
  • Optional remote operation using gigabit Ethernet
  • Optional on-board data storage
  • Built-in fans and front mounted connections

Description

The 6008U enclosure has 4 slots for Series 6000 input and output modules with a Universal Serial Bus (USB 2.0) computer interface for programming, control and data output. Multiple enclosures can be combined for larger and/or distributed installations. 6008U is DC operated for mobile applications.

All connections are made on the front allowing the 6008U to be located in the tightest of spaces. It has integral fans that supply cooling air to the modules and power supply. Power is 10 to 20 VDC with 21 to 32 VDC also available. An included power adapter is provided for operation from 120/240 VAC.

A sample clock bus is provided for multi rack installations. Programming and data transfer is USB 2.0, which provides high data transfer rates with low, predictable latency. It interfaces to the USB 2.0 port provided on most PC computers including laptops. Maximum length of the interface cable is 3 meters but it may be extended further using Ethernet with the Control & Data Processor (CDP) option.

Data Redundancy is optionally available. A 2.5" HD (Module 6095) mounts on the USB controller board in each 6008U enclosure and provides a redundant recording point for the DAS. In the unlikely event the Operators Workstation or DAS Software fails, data will continue to record in each enclosure. Data can be recovered from the system post-test.

The Operators Workstation (PCCOWU-LT) is the primary control and data recording point for the Series 6000 DAS. The PCCOWU-LT is typically a laptop, connected to the 6008U's USB port and runs PI660 Data Acquisition Software for system setup, calibration, display, recording, distribution and export.






Data Format  · Data Interface  · Operation  · Connections  · Mechanical  · Specifications  · Operators Workstation (PCCOWU-LT) (Optional)  · Ordering Information 

Data Format

Data Word

16 or 32-bits, 2's complement binary

Scan Table

Maximum format length is 65,536 samples

Sample Rates

Multiple sample rates consisting of the highest sample rate divided by binary numbers. Highest sample rate is programmable with 1 uS resolution


Data Interface

Output Rate

Processor dependent, typically over 5 million 16-bit samples/second

Latency

Processor and scan table dependent, typically less than 5 milliseconds

Clock Stability

100 ppm over temperature range


Operation

Protocol

Control and data interface is USB 2.0

Software

Windows 10 64-bit driver provides a high-level operating command set. Fully compatible with all implementations of PI660 operating software.

Control Inputs

TTL inputs for Start, Stop and Trigger assert flags in the header of output data that initiate software control operations

Alarms

Warning and alarm buses may be independent or shared between enclosures and may initiate an output from a digital I/O type module


Connections

Calibration

15-Pin Type D mounted on rear panel. Mating connector supplied.

Control

9-Pin Type D mounted on rear panel. Mating connector supplied.

Synchronization

Sampling clock synchronization for multiple rack systems. RJ45 connector on controller board. Category 5, 2-meter cable supplied.

USB

2-meter cable supplied.


Mechanical

Power Input

10 to 20 VDC. (21 to 32 VDC available on special order)

Operating Temperature (Mechanical)

0 to +50 ºC

Humidity

95% without condensation

Width

View
13.4 in

Height

View
7 in

Depth

View
16.7 in

Weight

Approximately 30 pounds with all channel modules


Specifications

Accessories

6085 - Connector Interface Panel for 6005 Enclosures. I/O module specific.


Operators Workstation (PCCOWU-LT) (Optional)

Operating System

Windows 10, 64-Bit.

Processor & Memory

Intel Core i5 or better. 2 GB RAM

Media

160 GB SSD or better and CD/DVD. Larger disk drives available.

Ethernet

Gigabit Ethernet

Display

15 in

Power

115 or 230 VAC, 47 to 63 Hz.

Operating Temperature

0 to +50 ºC

Size

Laptop (other configurations available)


Ordering Information 

Ordering Information

6008U - Enclosure, 4-slot, 12VDC USB Interface
6095 - Redundant Hard Drive

PCCOWU-LT - Operators Workstation. Laptop.


 DOWNLOADS 

Model 6008U
(PDF, 86KB)


© 2022, Pacific Instruments, Inc. Catalog IndexPrivacy PolicySite Map