Series 6800 for portable applications is a ready-to-run, high performance measurement system that is DC powered for mobile applications. All connections are front mounted for easy installation in tight places or on the go. 6800 systems come equipped with a conditioner, amplifier, filter and digitizer. Each channel has a front mounted connector specific to a measurement type: RJ-45 for 8-wire bridge transducers and BNC for voltage or ICP/IEPE inputs. Individual channels have a differential ±10V input and can digitize and record data to 16-bit resolution with upper and lower programmable alarm capability that is checked each time the output is digitized. Solutions are available for providing digital outputs based on these alarm conditions.
Systems interface to a familiar Windows based Operator Workstation over USB where the included software, PI660, is used for setup, display and acquisition of measurement data. PI660 allows for acquisition and control of one or many 6800 systems and provides real time data display. Data can be displayed and recorded in any number of ways, creating a versatile system that can fit any application and can be easily expanded or customized, should test requirements change.
Multiple systems can be combined for larger and/or distributed installations, made capable with an onboard, distributed sample clock bus. Programming and data transfer are over USB which provides high data transfer rates with low, predictable latency. It interfaces to the USB port provided on most PC computers, including laptops for ultimate portability.
Data Redundancy is optionally available. A 2.5" HD (Model 6095) mounts on the USB controller board in each system and provides a redundant recording point for the DAS. In the unlikely event the Operator’s Workstation or DAS Software fails, data will continue to record and can be recovered from the system post test.
The Operator’s Workstation (6800-PCCOWU-LT) is the primary control and data recording point for the Series 6800 DAS. The PCCOWU-LT is typically a laptop, connected to the USB port and runs PI660 Data Acquisition Software for system setup, calibration, display, recording, distribution and export.
4-Pole
6-Pole
8-Pole
8 channels, 2 to 8 wire with guard shield. Bridge config is programmable for 1/4, 1/2 and full bridge. 350 Ohm completion resistor standard, alternate value may be specified.
Differential, 2-wire with shield.
±10 Volts full scale, 20 mA. Programmable for wideband or filtered response.Buffered Analog Output.
Alternate input for external calibration source. Programmable 1, 0.1 and 0.01, attenuation with ±0.02% accuracy. Attenuator output may be connected to output bus for accuracy check.
Window's driver (Both 32 and 64-bit) provides high-level operating command set. Fully compatible with all implementations of PI660 operating software
Warning and alarm buses may be independent or shared between enclosures and may initiate an output from a digital I/O type module.Two alarms each with upper and lower limits that are programmable from negative to positive full scale. Limits checked on each ADC sample.
15-Pin Type D mounted on rear panel. Mating connector supplied.
Input connector is 50-pin Type D. Output is 15-pin Type D High Density. Mating connectors are supplied.
6815-16 - 16-Ch 12VDC Portable DAS, 8 Voltage/IEPE BNC & 8 Strain/Bridge/LVDT RJ45
6815-32 - 32-Ch 12VDC Portable DAS, 16 Voltage/IEPE BNC & 16 Strain/Bridge/LVDT RJ45
Signal Conditioning & Data Acquisition
Call: 
Signal Conditioning & Data Acquisition